Hmm, we didn’t seem to have that problem. Maybe try making sure the edges are wet from the spray so they hopefully stick better? Otherwise your idea of trimming things out for a clean look could work. Maybe you could use a dab of caulk to hold some thin wood trim on (caulk is rubbery and peelable or cuttable with an exacto when it comes time to remove it). Good luck!

xo,
s

I have recently used window frosting film on my front door window and the sidelight. I found that it is nearly impossible to get all the bubbles out of the edges. I trimmed it with the exacto knife after it was up, pushing along the edge, but some places just wouldn’t stick unless I trimmed them a little more. Once trimmed a little more, the bubbles were gone, but I was left with an uneven look on the edges. As well, little pieces of trim/dust would get stuck underneath the film when I cut it with the knife, so I would have to lift it up which resulted in bubbles that are nearly impossible to get rid of with the squeegee.

Your job looks perfect, but perhaps that is because you didn’t highlight the imperfections. Would you say that your frosting film actually looks seamless?

What suggestions do you have for me? Do you think there is a product (such as quarter-round for floors) for windows that is very thin and non-permanent that I can use to hide the messy edges?

Hey Abby,

Yup, the stuff we used can be removed by peeling it back and using warm soapy water to get rid of any haze or stickiness. Just be sure to read the package for the stuff you get to be sure it’s removable too!

xo,
s

Do you know whether frosting film can be removed from windows? I’d like to add some to my basement windows, but my condo board is responsible for window maintenance and may not like any permanent changes.

Any thoughts?

Abby

Hi Suzie,

Perhaps you’re thinking of someone else? We haven’t actually tackled an etching project yet (although it’s on our list!). Sorry we can’t point you in the right direction here on YHL, but maybe you’ll have luck googling around for something? Happy hunting…

xo,
s

I was hoping this was the post I was looking for, but it wasn’t! Bummer. I am looking for the tutorial you had on etching glass. Didn’t you etch just about every glass bottle and jar in your house? Would you please direct me to that post?

Thanks
Suzie

No idea! Maybe visit a craft store or home improvement store to see what they have. We don’t think spray adhesive will stand up to the humidity in there. Good luck!

xo,
s

Great tip Christina! Thanks for sharing.

xo,
s